Clear-Com HXII-BP-X4 2-Ch Full-Duplex Digital Intercom Beltpack with XLR-4M Jack

A full-duplex 2-channel digital partyline beltpack from Clear-Com, the HXII-BP can carry power and audio over an XLR cable or PoE (power over ethernet). The X5 model of the HXII-BP comes with a 4-pin male XLR connector. Each beltpack enables the selection of up to 2 of any 24 available HelixNet channels, plus program feed on the system. With the ability to talk on and/or listen on the selected channel, the user can listen via a headset and can talk via a headset mic.

The HXII-BP’s menu screen allows users to independently select among and change channel assignments as necessary, from any position on the intercom line. The beltpacks can be set up in a daisy-chain or star configuration with optional Y cable without the need for active splitter boxes. The brightness level of the OLED screen, Talk and Call buttons can be controlled from the beltpack. The OLED screen can show the level adjustment and then will revert back to the standard 2-channel screen.

Features

• 3-pin XLR and RJ-45 Ethercon intercom connectors on the bottom panel
• Power and audio over a PoE or single XLR cable
• Access to any 2 of up to 24 available channels on each beltpack
• Stacked key addresses multiple channels
• USB flasher mode
• Program audio with separate program level control
• Recessed level rotary knob controls
• Pushbutton menu access
• 10-character yellow OLED label display
• USB Micro-AB port
• XLR-4M headset jack
• Rugged, light-weight poly-carbonate casing
• IP-53 rated for dust and water ingress

Specifications

• Channels
  • Two intercom channels (Selectable) Program Audio (Assignable from Main Station)
• Connectors
  • Intercom Line: 3-pin XLR–F
  • LAN/PoE: RJ-45 etherCON
  • Headset: 4-pin XLR–or 5-pin XLR-F
  • USB: Micro AB
• Microphone Pre-Amplifier
  • Headset Mic Impedance: 200Ω (Dynamic)
  • Headset Mic Voltage: 1.7V (Electret selectable)
  • Limiter: +23dB
  • The following specified for a route to four-wire output at 0dBu out
  • Mic Gain: 60dB (Dynamic), 45dB (Electret)
  • Frequency Response: 300Hz – 10 kHz ±3dB, contoured for Intelligibility
  • Distortion:
  • Noise:
• Headphone Amplifier
  • Load Impedance: >32Ω
  • Output Level: +12dBu before clipping
  • Sidetone: -12dBu (selectable)
• The following specified for a route from a four-wire input at 0dBu in
  • Max Gain: 0dB
  • Frequency Response: 40Hz – 10kHz ±3dB
  • Distortion:
  • Noise: -65dBu
  • Headphone Limiter: 0dBu (selectable)
• Power Requirements
  • 4W DC Voltage Range: 30-60 volts 4W
  • Power-over-Ethernet (PoE)
• Environmental
  • 32°F to +104°F (0°C to +40°C)
  • 0 – 90% relative humidity
  • Dimensions
  • 5.3 x 3.9 x 1.7 in (HxWxD)
  • (135 x 99 x 43 mm)
• Weight
  • 12.2 oz (0.35 kg)